|
Plasma arc cutting devices PRO-CUT®
compact, economic
and high performance through thick and thin
High cost effectiveness and first-class cutting quality are the particular features of the portable Schweißkraft plasma arc cutting devices. Guaranteed reliability in the hard use in the industry and craft.
Universal applicability
Stainless steel, aluminum, steel, non-ferrous metals as well as other electrically conductive metals also with lacquered surfaces are cut without problems
From thin steel sheets up to thick plates
Separating cuts and quality cuts
Optimum cutting quality with steep angle edge for hand and contour cutting
Due to precisely controlled cutting current
Infinitely variable
High-performance reserves guarantee best material penetration, also at otherwise critical cutting ends
Safe striking
HF pilot arc striking (PRO-CUT 70/90)
Contact striking for PRO-CUT 35
With contact as well as contactless
Safety for persons and the machine
Protection class IP 21, appropriate to be used at workplaces with increased electric danger
Maximum cost effectiveness
Due to high cutting speed
Due to high durability
Due to reduced rework due to better cutting quality, also at the end of cuts
Due to demand-oriented post gas flow time
Due to Hot-Start function for striking immediately, also in the post gas flow time
Due to low connected load, high efficiency factor and performance factor
Easy handling
Due to compact and mobile design
Portable, therefore appropriate for almost any field of application
good handling when transporting due to little weight
With shoulder strap
Little operating cost
No cost for carrier gases such as for autogenous cutting
Compressed air as plasma gas are available at low cost
Process
Plasma arc cutting
Cutting performance
Up to 30 mm separating cut
Parent metals
All electrically conductive metals, also coated
Stainless steel
Aluminum
Steel
Non-ferrous heavy metal
Typical applications
Plant engineering, container , machine , steel construction
Construction of chemical plants
Overhaul / Maintenance
Industry plants and pipeline construction
Assembly companies
| Technical data |
PRO-CUT 90 |
| Welding torch type (connection) |
Euro |
| Set-point range (A) |
26 – 90 |
| Quality cut steel (ST37) (mm) |
25 |
| Separating cut steel (ST37) (mm) |
30 |
| Quality cut stainless steel (mm) |
25 |
| Separating cut stainless steel(mm) |
27 |
| Quality cut ALUMINUM (mm) |
23 |
| Separating cut ALUMINUM (mm) |
25 |
| Air requirement (lt/min.) |
200 |
| Pressure (bar.) |
5 |
| Power supply (V) |
3 x 400 -10+15% |
| Frequency (Hz) |
50/60 |
| Open-circuit voltage (V) |
250 |
| Power input plasma (kVA) |
15,3 |
| Max. current input (A) |
26 |
| Fuse protection (A) |
25 slow-blow |
| Operating time plasma (%) |
90 – 40% |
| Welding current plasma ED 100% (A) |
55 |
| Power factor [cos phi] |
0,85 |
| Protective system |
IP 21 S |
| Insulation class |
F |
| Working temperature (°C) |
-10 +40 |
| Dimensions (mm) |
420 x 180 x 270 |
| Weight (kg) |
17 |
Scope of delivery:
Plasma device, welding torch 6m, ground cable, incidentals, operating instructions
|
