|
Thread Repair Kits
Special
the Set includes:
Drill HSS
STI Bottoming Tap HSSG
Inserting Tool
Tang Break Tool
Wire Thread Inserts - type: “free running“ - length: 1.5 D
| for Thread |
Inserting Tool |
Tang Break Tool |
Drill |
Thread Inserts pcs
1,5xD |
Art.Nr. |
| UNEF 1/4 x 32 |
EBW06 |
BZ006 |
6,6mm |
10 |
B4225 |
| Harley 1/4 x 24 |
EBW06 |
BZ006 |
6,6mm |
10 |
B4226 |
| Harley 7/16 x 16 |
EBW10 |
BZ010 |
11,5mm |
10 |
B4227 |
| Cummins 11/16x16 |
EBW14 |
|
|
10 |
B4228 |
| Carburetor 7/8 x 20 |
EBW22 |
|
|
10 |
B4229 |
| Carburetor 1“ x 20 |
EBW24 |
|
|
10 |
B4230 |
 |
1.Drilling
Clear the damaged thread with a standard drill.
To repair a spark plug thread no pre-drilling
is necessary if using the special spark plug tap. |
 |
2.Tapping
Use the special BaerCoil taps for cutting the
holding thread into the hole. It is recommended to
use a suitable cutting oil. |
 |
3.Install the insert
Place insert on the installation tool ans position
the adjustable ring so that the insert tang is
centred in the tang slot. Wind the insert with a light
downward pressure until a half turn below the surface.
Don't worl against thread direction as the tang could
break. |
 |
4.Tang removal
Lift the tool from tang, turn tool 90° and tap
down sharply. Use tang break-off tool where supplied.
For bigger sizes and spark plug use a long nose pliers
to remove the tang. |
Instruction for use
|
